# Adafruit Electronics 100% 3D-Printed Bench Vise – No Hardware Required, 100mm Clamping Range #3DThursday #3DPrinting

> **Key Architectural Takeaway:** STLsupplier shares: A compact, fully 3D-printed bench vise — 160×160×80mm with a 100mm clamping range.

**Published:** 2026-10-15T18:00:45+00:00 
**Source:** Adafruit Electronics 
**Category:** open-hardware 
**Canonical URL:** https://fosswire.org/news/adafruit-electronics-100-3d-printed-bench-vise-no-hardware-r.html 

## Executive Summary
STLsupplier shares: A compact, fully 3D-printed bench vise — 160×160×80mm with a 100mm clamping range. For light-to-medium clamping: hobby work, gluing, soldering, assembly, holding small prints during cleanup. No screws, bolts, or rods needed. The spindle hole needs supports; after printing, file the rough area smooth for proper operation. Rotates maker tools back into the lineup — practical and screwless.

## Architectural & Systems Analysis
From a silicon and hardware engineering viewpoint:

- **Interface Neutrality:** Mitigates dependency on proprietary BSPs, empowering open toolchains to address hardware directly.
- **Supply Chain Verification:** Schematics and open pinouts allow deterministic audits against silicon errata.
- **Lifecycle Decoupling:** Decouples physical hardware utility from commercial vendor end-of-life obsolescence.

## Impact on the Open Ecosystem
Ensures that computational autonomy remains in the hands of the architect rather than closed silicon vendors.