# Emporia Vue 3 energy monitor liberated with ESPHome firmware for local-only Home Assistant use

> **Key takeaway:** Community-developed ESPHome firmware replaces the stock cloud-dependent firmware on the ESP32-based Emporia Vue 3, enabling fully local energy monitoring via Home Assistant.

**Published:** 2026-11-17T20:12:42+00:00 
**Source:** Adafruit Electronics 
**Category:** open-hardware 
**Canonical URL:** https://fosswire.org/news/emporia-vue-3-energy-monitor-liberated-with-esphome-firmware.html 

## Summary
The LTT Labs team has documented how to liberate the Emporia Vue 3 smart home energy monitor from its mandatory cloud connection by flashing it with open-source ESPHome firmware. The $199.99 device, which monitors up to 16 electrical circuits via current transformer clamps in a breaker panel, ships with firmware that transmits all energy data to Emporia's servers. Because the unit is built around an ESP32 microcontroller, it can be reprogrammed with community firmware that keeps readings entirely on the local network.

This local firmware builds on reverse-engineering work by Flaviu Tamas on the Vue 2 in 2021, with subsequent contributions from Maelstrom96, krconv, digiblur, and Cossid extending support to the Vue 3 in 2024. The measuring chips are identical across both hardware revisions, allowing a single firmware image to cover both. The LTT Labs test deployment in a 2,000 square foot Québec home tracked 11,903 kWh of consumption from March through September 2026, with granular cost attribution showing EV charging at $270 and heat pumps at $263 as the largest individual expenses.

## Hardware architecture and firmware replacement
- **ESP32 core:** The Emporia Vue 3 uses an ESP32 as its main microcontroller, making it reprogrammable with alternative firmware via standard ESP32 flashing tools.
- **Current transformer measurement:** The device uses current transformer clamps on the main feed wires and individual circuit hot wires, with identical measuring chips across Vue 2 and Vue 3 hardware revisions.
- **ESPHome firmware lineage:** The replacement firmware traces from Tamas's 2021 Vue 2 reverse engineering through community refinement by Maelstrom96 and krconv, with digiblur and Cossid adding Vue 3 compatibility in 2024.
- **Local network integration:** The flashed unit reports directly to Home Assistant rather than Emporia's cloud servers, keeping energy consumption data within the house network.
- **Circuit-level monitoring:** The 16-channel design enables per-circuit cost attribution, as demonstrated by the test deployment identifying EV charging and heat pump loads as dominant consumption sources.

## Why it matters
This development exemplifies a growing pattern in open hardware where cloud-tethered consumer devices are being liberated through community firmware, reducing dependency on vendor infrastructure and improving privacy for home energy data. For the Home Assistant and broader home automation ecosystem, it provides a cost-effective, locally-controlled alternative to proprietary energy monitoring solutions that would otherwise require persistent internet connectivity and third-party data custody.