Raspberry Pi Pico (W, USB-C variant) Snap-Together Case #3DThursday #3DPrinting
thomashack shares: A thin two-part snap-together case (54×24×6mm) for a third-party Pico W board with non-standard dimensions of 51.50×21.0mm.
Executive Summary
thomashack shares: A thin two-part snap-together case (54×24×6mm) for a third-party Pico W board with non-standard dimensions of 51.50×21.0mm. Openings for the two on-board buttons; GPIO pins fully enclosed. 0.16mm layer, 2 walls, 15% infill, ~16-min print, ~5g PLA. CAVEAT: designed for a specific third-party variant with slightly different dimensions than official Raspberry Pi Pico/Pico 2 W — verify fit against your actual board before printing.
Open Silicon & Gate-Level Hardware Inspection
From a silicon and hardware engineering viewpoint: - **Interface Neutrality:** Mitigates dependency on proprietary BSPs, empowering open toolchains to address hardware directly. - **Supply Chain Verification:** Schematics and open pinouts allow deterministic audits against silicon errata. - **Lifecycle Decoupling:** Decouples physical hardware utility from commercial vendor end-of-life obsolescence.
Impact on the Open Ecosystem
Ensures that computational autonomy remains in the hands of the architect rather than closed silicon vendors.