PicoCentrifuge: open-source $50 lab centrifuge built on Raspberry Pi Pico
A fully open-source DIY centrifuge using a Raspberry Pi Pico and drone motor achieves ~$50 cost versus $800-$3,000 commercial units, with published code, hardware designs, and bill of materials.
Summary
Thomas at Comfyspace.tech has released PicoCentrifuge, a low-cost laboratory centrifuge built around a Raspberry Pi Pico RP2040 microcontroller, an A2212 brushless drone motor, and a 30A electronic speed controller. The device is designed for biology workflows such as PBMC isolation over Ficoll, which requires approximately 400 x g centrifugal force for 30 minutes with gradual deceleration. The complete project is published as open-source hardware and software, including firmware code, hardware designs, and a full bill of materials.
The maker estimates total cost at roughly $50 using commonly owned maker equipment like a 3D printer, compared to $800-$3,000 for used commercial lab centrifuges handling 15 mL conical tubes. The project targets makerspaces, educational demonstrations, and budget-constrained teaching laboratories seeking accessible wet-lab infrastructure.
Hardware architecture and open-source release
- MCU: Raspberry Pi Pico with RP2040 dual-core Cortex-M0+ processor running the control firmware.
- Motor and drive: A2212 brushless DC motor (common in drone applications) paired with a 30A ESC for variable-speed rotation control.
- Mechanical construction: 3D-printed enclosure and rotor assembly, designed to spin sample tubes at sufficient velocity to achieve density-based separation.
- Performance target: Configured to deliver approximately 400 x g relative centrifugal force for 30-minute PBMC isolation protocols with controlled coast-down.
- Open-source deliverables: Complete firmware source code, hardware design files, and bill of materials published for replication and modification.
Why it matters
PicoCentrifuge demonstrates how commodity embedded hardware and 3D printing can democratize scientific instrumentation, lowering barriers for biology education and community labs. The project's fully open release model aligns with growing momentum in open hardware for science, where reproducible designs help institutions avoid proprietary equipment lock-in and enable localized manufacturing.
Original reference: blog.adafruit.com →